![]() Then just extrude what you've made and you'll have your pattern. ![]() If you want to do this, all you have to do is make smaller hexagons inside of the preexisting ones. Now I am assuming that you want an outlined honeycomb pattern sort of like the file that the user above me attached. Press apply and then you have your pattern started. Select every single side on your hexagon and then on the settings tab that pulled up, pick the tool that says "Mirror Line" and then select one of your sides.ħ. Now look to the toolbar at the top and locate the option that says "Mirror".Ħ. Draw the hexagon to the size that you want and hit confirm.ĥ. ![]() It will pull up a settings menu and obviously a honeycomb is a hexagon, so type in 6 sides if it isn't preset to 6.Ĥ. Look at the bottom and select the "Polygon" toolģ. Go into the sketch Tab and click on the down arrow under the rectangle tool.Ģ. Here's what you need to do to make a honeycomb pattern.ġ. I realize that this is 3 years after you asked this question, however I stumbled across this thread and figured I would reply even though you've probably either figured it out or given up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |